Collapse AllExpand All

3.5. Capacity Buffer Status by Work Center

The Capacity Buffer Status display provides information on your current capacity buffer levels. Capacity buffers apply to work centers. The Capacity Buffer screen enables us to view the current load in relation to a definable number of days of capacity. Keep in mind that buffer status information will only be displayed on days when the constraint management system is run. If you find your displays show no information, this probably means constraint management has not been run.

To view capacity buffer status by work center, go to Status > Capacity. The following screen will appear:

Capacity Buffer Status by Work Center

Note

When the buffer status for a work center hits 66 or higher, the status number will become red. By highlighting lines which are red hot, the system is informing you which should be acted on immediately. The best remedy for red hot item sites is to expedite any associated work orders or purchase orders.

When displaying capacity buffer statuses by work center, you are presented with the following options:

Show Work Centers

Specify which work centers you want to include in the display:

All Work Centers

Select to display capacity buffer statuses for all work centers.

Selected

Specify work center whose inventory buffer status you want to display.

Show Tooling

Select if you want to include tooling capacity information in the display. The following options are available:

All Tooling

Select to include capacity information about all tooling items in the display.

Selected Tooling

Specify tooling item whose capacity information you want to include in the display.

All Sites

Select to display capacity buffer statuses for all sites.

Selected

Specify site whose capacity buffer statuses you want to display.

Max Days Load

Specify the maximum number of days worth of work center load you want to view, using the arrows to the right of the field. This is required information. You must enter a value greater than zero to generate buffer status information. The system uses the following equation to determine the capacity buffer status for a work center:

(Total Setup + Total Run) / (Max Days Load x Daily Capacity) = Buffer (%)

Note

By default, the display will sort work centers by buffer status in descending order. In other words, work centers with the highest buffer status will appear at the top of the list; work centers with the lowest buffer status will appear at the bottom.

Buffer Status by Work Center

Display lists capacity buffer status by work center, using the specified parameters.